Axminster AWFS18 Operations Instructions download pdf (Page 6)

8. When cutting a large piece of material, support it at

the height of the table.

9. Do not feed the workpiece through the blade too

fast. Feed only as fast as the blade will cut.

10. Keep your ﬁngers away from the blade. Use a push

stick as you near the end of the cut.

11. Take care when cutting a workpiece which is

irregular in cross section. Moulding for example must

lie ﬂat, and not ‘rock’ on the table as it is being cut. A

suitable support must be used.

12. Take care when backing off a workpiece from

the blade, as the blade may bind in the ‘kerf. In this

event, switch OFF the machine and disconnect from

the supply. Wedge open the kerf, and withdraw the

workpiece.

13. Switch off the saw, and make sure the blade has

come to a complete stop before clearing sawdust or

off-cuts from the table.

14. Make sure there are no nails or foreign objects in

the part of the workpiece to be sawn.

15. Be extra cautious with very large or small, or

irregularly shaped workpieces.

16. Set up the machine and make all adjustments with

the power OFF, and disconnected from the supply.

17. DO NOT operate the machine with the covers off.

They must all be in place and securely fastened when

performing any operation

18. Be sure to use the correct blade size and type.

19. Use ONLY approved replacement saw blades.

Contact your local Axminster Tool Centre for advice.

The use of inferior blades may increase the risk of

injury.

Your scroll saw is fully assembled, except for the Blade

Guard, Air delivery tube and NVR switch assembly. To

attach these components, you will require a 3 & 5mm

allen keys and 17mm spanner, then proceed as follows:

Mounting the Blade Guard:

1) Undo the two grub screws on the scroll saw’s cast

iron arm blocks using the supplied 3mm allen key. (See

ﬁg 1).

2) Locate the angle support rod (E) and slide it through

the two pre-drilled holes in the cast iron blocks.

(See ﬁg 2). Lightly tighten the grub screws.

3) Undo the butterﬂy bolt on the blade guard (D), line

up the pre-drilled hole with the angle support rod (E)

and slide it into position. Angle the guard until you

are happy, then re-tighten the butterﬂy bolt. (DO NOT

OVERTIGHTEN) (See ﬁg 3)

Speciﬁcations

Model AWFS18

Product Code 501201

Rating Trade

Power 120W

Throat 460mm(18”)

Stroke 10 and 20mm

Cuts per Minute 400-1,400

Max Depth of Cut 65mm

Table Size 460 x 235mm

Table Tilt 0-45°

Overall L x W x H 620 x 285 x 310mm

Weight 29kg

Additional Safety Instructions for Scroll Saw

Initial Assembly

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments

Axminster AWFS18 Operations Instructions Page 6

Comments to this Manuals

Related products and manuals for Circular saws Axminster AWFS18