Axminster SS-12VS Operations Instructions download pdf (Page 10)

Setting up

DISCONNECT THE SANDER

FROM THE MAINS SUPPLY

Remove all tools away for the machine, Switch on,

wait until the machine has reached full speed and

check that the disc sander is running properly ie, no

vibration or rattling for example. If not, switch off,

wait for the machine to come to a complete stop,

disconnect the sander and check all ﬁxing to make

sure they are tight. Reconnect, switch on and check

again. If everything is ﬁne, switch off and wait until

the machine has come to a complete stop.

Dust Extraction

The dust extraction moulding has a 63mm outlet,

insert a jubilee clip over the general purpose

extraction hose and insert it over the outlet and

clamp in place.

Also the disc sander comes with two adaptors (C)

and (D) see ﬁgs 09-10. Fit a general purpose hose

with either a 37mm or 100mm diameter and with a

jubilee clip, secure in place.

Fig 10

Vacuum cleaner hose connected to sanders adaptor

Fig 11

DO NOT OVERTIGHTEN AS THE

EXTRACTION OUTLET IS ONLY

PLASTIC AND CAN CRACK IF

DONE UP TOO TIGHT.

Alternately, if you have a vacuum cleaner with the

same diameter hose insert it over the outlet as before,

it should be a snug ﬁt. (see ﬁg 11)

Fig 09

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Axminster SS-12VS Operations Instructions Page 10