Axminster WD-20 User Manual download pdf (Page 19)

Maintenance

Excessive dust in the motor can cause excessive heat to develop. Every effort should be made to

prevent foreign material from entering the motor. When operated under conditions likely to permit

accumulations of dust, dirt or waste, a visual inspection should be made at frequent intervals.

Accumulations of dry dust can usually be blown out successfully.

Caution: To avoid eye injury or adverse reaction to dust, high pressure hoses should

not be used especially in poorly ventilated areas. The operator performing this cleaning

function should wear safety goggles and dust filter mask.

After cleaning all dust and debris a light coating of machine oil on the quill then to spread the oil.

If the machine is going to stand idle for any length of time, a light coat of spray or machine oil

over the column and table will prevent rusting.

DO NOT USE THE MACHINE IF THE POWER CABLE HAS BECOME DAMAGED.

If any servicing (other than the above cleaning) becomes necessary the unit should be returned

to your supplier or repaired by a qualified electrician.

N.B. The speed of the motor cannot be regulated or changed - no adjustment is necessary.

Oil

OIL

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

No comments

Axminster WD-20 User Manual Page 19