Axminster SIEG X1 Super Micro Mill Mk2 User Manual download pdf (Page 7)

Definitions

Specifications (Continued)

‘X’ Axis. This is the axis described by the work table as it is moved side to side.

Normally, movement that moves the tool to the right in the workpiece is

referred to as +ve ‘X’, and movement that moves the tool to the left in the

workpiece is referred to as –ve ‘X’. Where the initial position of the tooling and

the worktable is designated 0,0. (Horizontal plane only).

‘Y’ Axis. This is the axis described by the work table as it is moved from front to back.

(Traverse) Normally movement that moves the tool to the front in the

workpiece is referred to as-ve ‘Y’, and movement that moves the tool to the

rear in the workpiece is referred to as+ve ‘Y’. Where the initial position of the

tooling and the worktable is designated 0,0.(Horizontal plane only).

‘Z’ Axis This is the axis described by the worktable in the vertical plane. (Not possible

with this machine). However, to establish a point in space, the co-ordinates

can be transferred to the ‘tip’ of the tooling, whereby, if we assume that the

tool and the worktable in their initial positions, where designated 0,0,0,

(Horizontal and vertical planes) any point above the tool tip is referred to as

+ve ‘Z’, and any point below the tool tip is referred to as -ve ‘Z’

Quill Travel:

Quill Mandrel Taper:

Reversing Method:

Draw Bar Thread:

Driling Capacity

End Mill Capacity:

Face Mill Capacity:

Overall L x W x H:

Weight:

30mm

2MT

Electrical

M10

10mm

20mm

430 x 355 x 715mm

32Kg

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Axminster SIEG X1 Super Micro Mill Mk2 User Manual Page 7