Axminster WS1000TA Specifications download pdf (Page 23)

Setting up the Machine

5mm

Fig 59

Adjusting the feeder roller & ant-kickback assembly

Fig 61

Fig 60

Loosen the feeder roller clamping knobs (a and b) & move the feeder roller to the centre of the workpiece,

tighten the clamping knobs. Undo the anti-kickback clamping knobs (c and d) and move the assembly near the

workpiece, tighten the clamping knob (c), raise the assembly so the steel plate is about 5-10mm above the work

table (See figs 60 & 61).

5-10mm

Fig 62

Fig 63

Leveling the sliding table

Place a level between the sliding table & work table & check that both tables are level. If not loosen the three nuts

(e) beneath the sliding table and adjust the two coach bolts (f), until the bubble on the level is between the two

markers (g), tighten the three nuts (e) (See figs 62 & 63).

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

No comments

Axminster WS1000TA Specifications Page 23